WCCO first learned about SynerFuse​ in 2023​ after a patient shared her chronic pain journey and the successful results a year after the surgery.

Dr. Jeff Lehmen, a spine surgeon at SSM St. Mary's Hospital, said this assumption could be a sign of lumbar disk herniation, ...

MRI has revealed that the most common sites of LDH are the lumbar spine regions L4–L5 and L5–S1 (4). This meta-analysis evaluates ... studies in which no surgery was used to treat LDH. Any ...

Legendary golf personality John Daly shared an update on his health over social media, approximately two months removed from undergoing emergency surgery for a hand injury. Now, Daly appears on ...

targeted exercises can increase the blood flow to the lower back area, which can help reduce stiffness. Pair these exercises with one of the best office chairs to give you proper lumbar support ...

Acupuncture. Massage. Muscle relaxants. Cannabinoids. Opioids. The list of available treatments for low back pain goes on and on. But there’s not good evidence that these treatments actually ...

with medication being the first step and surgery being the last, more drastic measure. However, a new review published on Tuesday in BMJ Evidence Based Medicine reports that only one in 10 ...

Moderate quality evidence showed that treatments for acute low back pain that weren't effective included exercise, steroid injections and paracetamol, while anaesthetics (i.e. Lidocaine) and ...

The treatment varies by the causes but may involve medications, physical therapy, bracing, or surgery ... Compression of this part of the spine is most often the result of herniated discs, bone spurs, ...

NORTH PORT, Fla. -- What does it feel like when you conclude the first inning you've pitched in nearly a full calendar year with consecutive strikeouts, the second of which was registered with a 98 ...

VoxelMatters has spent some time testing the Kobra S1 from Anycubic’s Kobra S1, the Chinese desktop 3D printer manufacturer‘s first CoreXY printer. If the design looks familiar, well – let’s just say ...